FREE SHIPPING ABOVE SG$150 / SIGN UP OUR NEWSLETTER TO GET $5 OFF YOUR FIRST ORDER

Daniel Wellington Guide

Daniel Wellington Guide on how to change straps



How do i change from a leather band to natoband and vice versa?
To start with, in order to place or remove the leatherband you will need a pin, a paperclip or a very small/thin tool. First, remove the natostrap from the watch. Second, locate the small hole on the outside of the watch-case (where the leatherband are to be attached) and gently press the pin on the hole while you waggle the peg. Inside the hole, there is a spring loaded spike that will move out from the watch-case once you have done the previous mentioned steps.


There are holes at the end of the leatherband where you can plug in the spring so that the pegs are visible on either side of the hole. Continue by placing one of the pegs inside the small hole on the watch-case which will position the spring in the same position as when it was first loosened. Now gently press in the other peg (the one that you did not place inside the small hole) with your nail and move the spring towards its starting position until you see/hear the spring click in to the hole. Repeat the same steps with the opposite side of the leatherband and the switch is made.